NEC Univerge SV9100 - Adjusting the Height on the Multiline Terminal

UNIVERGE SV9100 Issue 1.2
System Hardware Manual 5 - 63
9. Press Soft Key 4 for OK to complete.
10. Continue pressing Soft Key 4 to exit (Exit-Exit-Save). The
terminal will reset automatically.
4.8 Adjusting the Height on the Multiline Terminal
The height of the DT300/DT700 Series Multiline terminals can be adjusted by
moving the legs attached to the bottom of the terminal.
1. Turn telephone over (button side down).
2. Adjust legs to desired height (refer to Figure 5-55 Adjust Height of
DT300/DT700 Series Terminal on page 5-63).
3. Turn telephone over (button side up).
Kit6 Value 6-Button
Kit2 Value 2-Button
Kit0 IP-CTS
Figure 5-55 Adjust Height of DT300/DT700 Series Terminal
Table 5-15 Line Key Kit Type (Continued)
Line Key Kit Entry Description