UNIVERGE SV9100 Issue 1.2
System Hardware Manual 4 - 25
3.1.5 Connectors
Table 4-9 GCD-CP10 Connections describes each connector on the
GCD-CP10
, Table 4-10 GCD-LTA RJ45 Cable Connector Pin-Outs
describes the pin-outs for connectors on the CCPU-A..
Blinking Off On On On Steady When
USB Memory is
Installing
Flash memory booting error
Blinking On On On On Steady When
USB Memory is
Installing
Flash memory data error
Blinking Blinking Blinking Blinking On Steady When
USB Memory is
Installing
Reading error of system
program
Blinking On Off Off On Steady When
USB Memory is
Installing
Error: Major alarm occured
Blinking Blinking Off Off On Steady When
USB Memory is
Installing
Error: Minor alarm occured
On Off Off Off Off System starting up
Table 4-9 GCD-CP10 Connections
Connector Connector Description
J13 USB Memory Connection (used for upgrading software
or downloading system data)
J4 Ethernet Cable Connection (for PCPro or WebPro, CTI,
ACD MIS, IP Phone)
J11/J12 Pin Jack for External Source Connection (External
MOH, External Speaker, etc.)
J10 External Source Control Connection
J6/S4 Used for Debug
J7 SD Memory Card Connection
J9 Backboard connection
J14 GPZ-IPLE connection
Table 4-8 GCD-CP10 LED Indications (Continued)
LED Indication
Status
RUN (D23) D20 D21 D22 D25
To Next Page
Loading...
