NEC Univerge SV9100

System Hardware Manual 2 - 1
Chapter
2
SV9100 System Specifications
SECTION 1 GENERAL INFORMATION
This chapter provides detailed specifications for the SV9100 system
technician. The technician should review this information carefully before
installing the system.
SECTION 2 SYSTEM BLOCK DIAGRAM
Figure 2-1 SV9100 System Block Diagram shows the Blades that can be
installed in the chassis and the number of channels supported when the
Blade is installed. Table 2-1 List of Abbreviations lists abbreviations used
in the diagram.
Table 2-1 List of Abbreviations
Abbreviation Description
Contact Center Automatic Call Distribution
ADA Ancillary Device Adapter
APR Analog Port Adapter (with ringer)
AUX IN/OUT BGM/MOH Port (on CPU)
BCH Bluetooth Cordless Handset
BHA Bluetooth Hub Adapter
BRI Basic Rate Interface
BRIDB Expansion Basic Rate Interface Daughter Board on BRI
BRT Basic Rate Interface Blade/ISDN Terminal Interface Blade
BUS0 BUS Interface Blade (for 1U chassis)
BUS1 BUS Interface Blade (for 2U chassis)
CCT CCIS Interface Blade
CF Compact Flash
CFT Conference Trunk (on CPU)
COT Central Office Trunk (Loop and Ground Start Interface)