Issue 1.2 UNIVERGE SV9100
5 - 144 Installing DT Series Digital and IP Multiline Terminals
2. To remove the clip, press the retaining clip in toward the belt clip blade
and slide the clip up at the same time.
10.13 Installing the Handset Battery Pack
Before installing batteries, refer to D
term ®
Cordless DECT Owner’s Manual
Specifications and Battery Safety. It is important to follow safety regulations
when handling batteries.
1. Remove the battery cover by pressing the latch and sliding the cover
down and off of the handset.
Figure 5-167 Removing the Belt Clip
Figure 5-168 Removing the Battery Cover
To Next Page
Loading...
