Issue 1.2 UNIVERGE SV9100
5 - 44 Installing DT Series Digital and IP Multiline Terminals
4.1.2 Connecting the Line Cord
Confirm the location of the line connector
on the bottom of the
multiline terminal. Then, connect the line cord to the multiline terminal
using the steps shown below.
4.1.2.1 Line Cord Connection DT300
1. Install the modular plug of the Line Cord into the Line
Connector at the back of terminal. Push until it snaps into
place. Refer to Figure 5-32 Installing the Line Cord (DT300).
2. Install the Line Cord in the groove. Refer to Figure 5-33 Line
Figure 5-31 Installing the Handset (DT400)
Figure 5-32 Installing the Line Cord (DT300)
To Next Page
Loading...
