NEC Univerge SV9100

Issue 1.2 UNIVERGE SV9100
4 - 88 Installing the SV9100 Blades
5. Install the Compact Flash drive into slot CN7, make sure the drive is
fully seated in the slot (refer to Figure 4-28 Install the Compact Flash
Drive).
6.1.3 LED Indications
6.1.3.1 Active LED – Green
The Active LED is controlled by the DSP and indicates the
board operational status.
o Off: Power off.
o On: Reset.
o Slow Flash: Board is running but not in sync with the chassis
yet.
o Fast Flash: Board is in sync with the chassis and operating
normally.
Figure 4-27 Install the SO-DIMM Memory
Figure 4-28 Install the Compact Flash Drive