NEC Univerge SV9100 - CHS LARGE BATT BOX to CHS2 UG Connection

Issue 1.2 UNIVERGE SV9100
3 - 64 Installing the SV9100 Chassis
16. Insert tabs on cover into holes on CHS LARGE BATT BOX. Slide the
cover left until seated and tighten the screw.
6.2.3 CHS LARGE BATT BOX to CHS2UG Connection
1. Power down the CHS2UG chassis.
2. Disconnect AC power cable from rear of chassis.
3. Remove fan access panel from rear of CHS2UG chassis.
Figure 3-87 Installing Cover Battery
Ensure the CHS2UG chassis is powered OFF.
Figure 3-88 Removing Fan Access Panel