UNIVERGE SV9100 Issue 1.2
System Hardware Manual 3 - 63
10. Using two screws, install the Battery Tray Bracket.
11. Insert Battery Connection Cable into cable guides.
12. Install the Battery Tray Cover and tighten the two screws.
13. Slide the Battery Trays into the CHS LARGE BATT BOX.
14. Install the Battery Tray Suppressor while pulling the Battery
Connection Cable(s) through the cutouts provided. Secure with two
screws.
15. Plug the Battery Connection Cable(s) into the Fuse Unit. Refer to
figure below.
Figure 3-85 Installing Battery Connection Cable
Figure 3-86 Connecting Battery Cables
To Next Page
Loading...
