Issue 1.2 UNIVERGE SV9100
3 - 62 Installing the SV9100 Chassis
7. Remove two screws and remove the Battery Tray Bracket.
8. Refer to battery cable connection guide below for connection of
battery cable to battery terminals. Repeat for additional battery
connection.
9. Install batteries into Battery Tray. Refer to figure below.
Figure 3-83 Removing Battery Tray Bracket
Incorrect Installation Of Batteries May Damage The
Fuse Unit Or Cause Possible Fire.
Figure 3-84 Battery Cable Connection Guide
To Next Page
Loading...
