Issue 1.2 UNIVERGE SV9100
3 - 46 Installing the SV9100 Chassis
4. Using supplied screws, secure the CHS2UG STAND KIT (K) to the
floor.
5. Connect the ground wire to all chassis. Refer to 1.1.3 Install
Grounding on 19” Chassis on page 3-13 for complete details on
grounding the system.
6. Refer to 1.1.5 Install AC Power Cords on 19” Chassis on page 3-15 to
continue installation of the chassis or, Chapter 6 paragraph 2.1
Installation and Safety Precautions on page 4-3 for installation of
blades.
4.2 Stand Mounting the 9.5” CHS2UG B Chassis
Figure 3-58 Install Additional Brackets from CHS2UG JOINT BRACKET KIT
To prevent possible damage to the 19” chassis due to
falling, NEC recommends screws be installed in the
stand mount brackets as soon as possible.
To Next Page
Loading...
