UNIVERGE SV9100 Issue 1.2
System Hardware Manual 3 - 27
2.2.2 Wall Mounting the 9.5 inch (CHS2UG) Chassis
1. Use the template shown above for required spacing before drilling.
2. Mark and drill four holes marked A, B, C and D.
3. Mount Anchor bolts (locally procured), in holes A and B drilled in step
2.
è Because the bracket (upper) will be hooked onto the head of the
anchor bolts, allow the head to protrude approximately 0.14 to 15
in (3.5 to 4.0mm) from the wall (refer to (Figure 3-36 Anchor Bolt
from Wall (9.5” Chassis) on page 3-28).
Figure 3-35 Wall Mount Spacing Guide (9.5” Chassis)
To Next Page
Loading...
