UNIVERGE SV9100 Issue 1.2
System Hardware Manual 3 - 79
6. Reconnect AC power cable to rear of 9.5” chassis.
7. To power on the 9.5” chassis, refer to Chapter 4, 2.6 Powering Up the
SV9100 on page 4-9.
6.4.3 CHS LARGE BATT BOX Fuse Replacement
To replace the fuse(s) in the CHS LARGE BATT BOX, refer to Chapter 3,
section 6.2.4 CHS LARGE BATT BOX Fuse Replacement on page 3-67.
SECTION 7 POWER SUPPLY
SECTION 8 REMOVE AND INSTALL COOLING FAN
If required, the cooling fan installed in the CHS2UG chassis can be removed and
replaced. Follow the procedure below for the CHS2UG chassis.
8.1 CHS2UG Chassis
Figure 3-111 CHSG LARGE BATT BOX to CHS2UG Connection
Do not attempt to replace the power supply on the CHS2UG chassis. The
MPS7101 is not a field replaceable part. If the power supply fails, contact
NEC.
To Next Page
Loading...
