UNIVERGE SV9100 Issue 1.2
System Hardware Manual 4 - 19
MF Sender
MFC Tone Sender
MF Signal Sender (Sends caller information to CO for E911)
Call Progress Tone Detection
C-Channel Control
Conference: 64 Channels (when built-in modem is enabled), or
96 channels (when built-in modem is disabled)
Caller ID Receiver; 32 Channels
A load switch which is used for initial system startup, resetting the
system, or when upgrading system software
One Serial Port (null modem/cross-over cable required)
One USB Port – USB 1.1/2.0
. Memory size - minimum of 32MB (normally 512MB or 1GB) should be
used.
. USB device power consumption is less than 200mA (1W)
One Gbit Ethernet Port for VoIP function
One CompactFlash Card Slot
Background Music/EXSP Control Port
Status LED
Two Audio Input/Output terminals
One Music on Hold External Source
BGM LED
EXSP Control LED
Two Audio Input/Output Terminals
One General Purpose Control Terminal
One Music On Hold External Source
HDLC Packet Processing
Real Time Clock (tolerance 30 seconds/month)
Internal MOH Generation
Call Control Server (ex: Conference Bridge Server, Voice Mail Server,
SIP Server, RTP Forwarding, VoCoder Conversion)
One lithium battery (CR2032 or equivalent) which provides battery
back-up of system data and RAM memory for approximately 30
months.
The GCD-CP10 functions provided are:
To Next Page
Loading...
