UNIVERGE SV9100 Issue 1.2
System Hardware Manual 5 - 139
5. Plug the other end of the short telephone cord into the modular wall jack
in the center of the wall plate.
6. Place the base unit on the posts of the wall plate and push down until it
is firmly seated.
. Because of variation in wall plates, this method is not recommended.
7. Plug the AC adapter into a standard 230 Vac wall outlet.
. Do not use an outlet controlled by a wall switch.
Figure 5-158 Placing the Base Unit on the Posts of the Wall Plate
Figure 5-159 Plugging the AC Adapter into the AC Wall Outlet
To Next Page
Loading...
