Issue 1.2 UNIVERGE SV9100
6 - 36 Installing SV9100 Optional Equipment
4. Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5. Lay the tilt leg and the leg support flat to expose ADA-L UNIT
compartment.
6. Carefully pry loose the knockout covering the bottom option
interface (refer to Figure 6-25 Bottom Option Interface
Knockout).
7. Using the exposed Bottom Option Interface as a guide, install
the ADA-L UNIT in the bottom of the DTL/ITL multiline terminal.
Push down until left and right tabs are seated (Refer to Figure
6-26 Install ADA-L UNIT).
8. Return tilt leg to original position.
9. Reconnect all cables previously disconnected.
Figure 6-25 Bottom Option Interface Knockout
Figure 6-26 Install ADA-L UNIT
To Next Page
Loading...
