NEC Univerge SV9100 - Page 49

UNIVERGE SV9100 Issue 1.2
System Hardware Manual 2 - 9
Table 2-4 Maximum System Capacities – Blades shows the maximum number for
each blade that can be installed in a system.
This is determined by the maximum blade configuration allowed. When installing
single line sets, DISA, or tie lines, CPU circuits must be allocated for DTMF receivers.
To install single line sets with CO/PBX line access, or when installing immediate-start
tie lines, CPU circuits must be allocated for dial tone detection.
Table 2-4 Maximum System Capacities – Blades
Hardware
9.5”
Chassis
19”
Chassis
with CPU
19”
Chassis
without
CPU
19”
Chassis
x4
Comments
Number of Slot(s) for Interface
Package
3 Slots 5 Slots 6 Slots 23 Slots
Common Control Blades:
GCD-CP10 1100 –
GPZ-IPLE
(VoIP Daughter Board)
1101This unit provides 256
VOIP Gateway
channels
GCD-SVR2
(Server Blade)
1111
Station Blades:
GCD-4DIOPB
(4 DID/OPX)
2 5 6 23 When installed as an
OPX blade
GCD-4LCA
(4 Single Line Telephone Interface)
25623 –
GPZ-4LCA
(4 Single Line Telephone Interface
Daughter Board)
25623 –
GCD-8DLCA
(8 Digital Station Interface)
25623
GPZ-8DLCB
(8 Digital Station Interface Daughter
Board)
25623
GCD-8LCA
(8 Single Line Telephone Interface)
25623
GPZ-8LCE
(8 Single Line Telephone Interface
Daughter Board)
25623