UNIVERGE SV9100 Issue 1.2
System Hardware Manual 2 - 13
SECTION 4 POWER-BASED CALCULATOR CHART
The Univerge SV9100 system uses two types of power factors. For a single chassis
chart refer to Table 2-6 Board Power Factor. For the maximum number of specific
blades per package, see Table 2-7 Maximum Number of Package Installed. Refer to
Table 2-8 Terminal Power Factor below, for the Terminal/ Adapter power chart.
Table 2-6 Board Power Factor
Board Power Factor
Total =<7
Item Power Factor
GCD-CP10 1
GCD-VM00 2
GCD-ETIA 2
GCD-PVAA 1
GPZ-IPLE 2
GCD-SVR2 2
GCD-RGA 1
Table 2-7 Maximum Number of Package Installed
Board
(Power Factor)
Maximum Number of Package Installed
9.5 inch
19 inch
with CCPU
19 inch
without
CCPU
4 x 19 inch
GCD-ETIA (2) 2 3 3 12
GCD-PVAA (1) 2 5 6 23
GCD-SVR2 2 2 3 11
GCD-RGA (1) 1111
To Next Page
Loading...
