Issue 1.2 UNIVERGE SV9100
3 - 12 Installing the SV9100 Chassis
1. Ensure Controlling and Expansion chassis are powered
down.
2. Using the NEC provided CAT5 straight-through cable(s),
attach one end to each Expansion Chassis CN2 connector
on the GPZ-BS11 blade (see Figure 3-21 System Expansion
Cabling on page 3-13). Attach the opposite end to the CN2,
CN3 or CN4 connector on the GPZ-BS10 of the Controlling
Chassis.
Figure 3-20 19” Expansion Chassis Interface Units
Expansion Chassis Interface Unit
for the Controlling Chassis
GPZ-BS10
Expansion Chassis Interface Unit
for the Expansion Chassis
GPZ-BS11
To Next Page
Loading...
