Program 16 to 20
Xen Topaz Programming Manual 136
PROGRAM 20: SYSTEM OPTION SETUP
20-14: C
LASS OF SERVICE OPTIONS FOR DISA/E&M
Description
Use Program 20-14 : Class of Service Options for DISA to enable/disable DISA Class of Service options.
You assign a DISA Class of Service to DISA users in Program 25-09. Up to 15 DISA Classes of Service can
be defined.
Note: Analogue trunk-to-analogue trunk and ISDN trunk-to-ISDN trunk calls are supported by this program.
However, analogue trunk-to-ISDN trunk and ISDN trunk-to-analogue trunk are not supported.
Input Data
IN
SA
SB
Class of Service Number 01-15
Prog.
No.
Item Input Data Default
Related
Program
20-14-01
-Not Used-
0 : Off
1 : On
-
20-14-02
Trunk Group Routing/ARS Access
This option enables or disables a DISA or tie trunk
caller’s ability to dial 9 for Trunk Group Routing or
Automatic Route Selection (ARS)
0
20-14-03
Trunk Group Access
This option enables or disables a DISA trunk caller’s
ability to access trunk groups for outside calls
(Service Code 814).
0
20-14-04
Common Abbreviated Dialling
This option enables or disables a DISA or tie trunk
caller’s ability to use the system’s Common Abbrevi-
ated Dialling.
0
20-14-05
Operator Calling
This option enables or disables a DISA trunk caller’s
ability to dial 9 for the telephone system operator.
0
20-14-06
Internal Paging
This option enables or disables a DISA trunk caller’s
ability to use the telephone system’s Internal Pag-
ing.
0
20-14-07
External Paging
This option enables or disables a DISA trunk caller’s
ability to use the telephone system’s External Pag-
ing.
0
20-14-08
Direct Trunk Access
This option enables or disables a DISA trunk caller’s
ability to use Direct Trunk Access (Service Code
815).
0
To Next Page
Loading...
