NEC Xen Topaz - Page 203

Program 21 to 25
Xen Topaz Programming Manual 196
PROGRAM 24: HOLD/TRANSFER SETUP
24-01: S
YSTEM OPTIONS FOR HOLD
Telephone Programming Instructions
To enter data for Program 24-01(System Options for Hold):
1. Enter the programming mode.
2. Enter 24 01
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
24-01-01
Hold Recall90
24-01-xx
xxxxx