NEC Xen Topaz - Page 265

Program 26 to 35
Xen Topaz Programming Manual 258
PROGRAM 35: SMDR AND ACCOUNT CODE SETUP
35-02: SMDR O
UTPUT OPTIONS
Input Data (Cont)
-SMDR Printout Format-
12345678901234567890123456789012345678901234567890123456789012345678901234567890
XX/XX/XX PAGE XXX
CLASS TIME LINE DURATION STATION DIALLED No./CLI RD/COST ACCOUNT
aa bbbb cc:cc dddddddddd ee:ee:ee ffffffffff gggggggggggggggg hhhhhhh iiiiiiii
*Column 1(aa) : Call Number
Indicate the number. Up to 55 calls are printout per a page.
*Column 2(bbbb) : Class of Call
Indicate the type of call as below;
*Column 3(cc:cc) : Time
Indicate a time(24 hours format) of incoming/outgoing/transferred call.
*Column 4(dd…) : Trunk Number/Name
Indicate a Trunk Number or Name.
IN
SA
SB
Prog. No. Item Input Data Default
Related Pro-
gram
35-02-10
All Busy (ALB) Output
0 : Not Output
1 : Output
0
35-02-11
Walking Toll Restriction Table
Number
0 : Not Output
1 : Output
1
35-02-12
DID Table Name Output
0 : Not Output
1 : Output
0
35-02-13
CLI Output When DID to Trunk
0 : Not Output
1 : Output
0
35-02-14
Date
Determine whether the date should
be displayed on SMDR reports. This
option must be set to “0” if the
trunk name is set to be displayed
in Program 35-02-03.
0 : Not Output
1 : Output
0
35-02-15 CLI / DID Number Switching
0 : Calling Party No.
1 : Called Party No.
0
35-02-16
Trunk Name or Received Dialled
Number (ISDN Only)
Determine how the SMDR should
print incoming calls on ANI/DNIS or
DID trunks. If set to (1), ANI/DNIS
trunks can print DNIS digits. If set to
(0) trunk names are printed instead
0 : Trunk port Name
1 : Received Dial
Number
0
0 = 14-01-01
1 = 22-11-01
Item Description Item Description
AIN
Incoming Call on Analogue Trunk
POT
Outgoing Call on Tie Line
AOT
Outgoing Call on Analogue Trunk
TOT
Outgoing Call by Tandem trunk
IIN
Incoming Call on ISDN Trunk
ALB
All Trunk Busy
IOT
Outgoing Call on ISDN Trunk
BRD
Barred Outgoing Call
PIN
Incoming Call on Tie Line
BFL
Buffer Full