NEC Xen Topaz - Page 306

Program 40 to 92
Xen Topaz Programming Manual 299
PROGRAM 80: BASIC HARDWARE SETUP FOR SYSTEM
80-03: DTMF T
ONE RECEIVER SETUP
Default
Conditions
None
Feature Cross Reference
♦ None
Telephone Programming Instructions
To enter data for Program 80-03 (DTMF Tone Detector Setup):
1. Enter the programming mode.
2. Enter 80 03
3. Enter the number of the item you want to program.
4. Select the DTMF Tone Receiver Type number to be programmed by pressing the FLASH or the VOL-
UME▲ or VOLUME▼ keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
MF
SA
SB
Prog. No.
Item
Type 1 Type 2 Type 3 Type 4 Type 5
80-03-01
Detect Level
1 1 1 1 1
80-03-02
Start delay time 0 0 0 0 0
80-03-03
Min. detect level 15(-25dBm) 15(-25dBm) 15(-25dBm) 15(-25dBm) 15(-25dBm)
80-03-04
Max. detect level 2 (-2dBm) 2 (-2dBm) 2 (-2dBm) 2 (-2dBm) 2 (-2dBm)
80-03-05
Forward twist level 5 (6dBm) 5 (6dBm) 5 (6dBm) 5 (6dBm) 5 (6dBm)
80-03-06
Backward twist level 0 (1dBm) 0 (1dBm) 0 (1dBm) 0 (1dBm) 0 (1dBm)
80-03-07
ON detect time 1 (30ms) 1 (30ms) 1 (30ms) 1 (30ms) 1 (30ms)
80-03-08
OFF detect time 1 (30ms) 1 (30ms) 1 (30ms) 1 (30ms) 1 (30ms)
80-03-01DTMF Re
Detect Level 0
80-03-xxDTMF Rex
xxxxx