NEC Xen Topaz - Page 311

Program 40 to 92
Xen Topaz Programming Manual 304
PROGRAM 80: BASIC HARDWARE SETUP FOR TRUNK
81-01: A
NALOGUE TRUNK INITIAL DATA SETUP
Input Data (Cont)
Conditions
None
Feature Cross Reference
♦ Central Office Calls, Placing
Telephone Programming Instructions
To enter data for Program 81-01 (Analogue Trunk Initial Data Setup):
1. Enter the programming mode.
2. Enter 81 01
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
Prog. No. Item Input Data
Default
81-01-27
-Not Used -
-
-
81-01-28
-Not Used -
-
-
81-01-29
-Not Used -
-
-
81-01-30 -Not Used -
-
-
81-01-31 -Not Used -
- -
81-01-32 -Not Used -
- -
81-01-33 Charging Pulse Minimum Duration Time
1-255 (8-2040mS) 9 (72ms)
81-01-34 Charging Pulse Minimum Period Time
1-255 (8-2040mS) 29 (232ms)
81-01-35 Charging Pulse Minimum Interval Time
1-255 (8-2040mS) 6 (48ms)
81-01-01
Compand'n Type0
81-01-xx
xxxxx