NEC Xen Topaz - Page 54

Xen Topaz Programming Manual 47
Program 10 to 11
PROGRAM 11: SYSTEM NUMBERING
11-12: S
ERVICE CODE SETUP (FOR SERVICE ACCESS)
Input Data (cont)
Conditions
None
Feature Cross Reference
Refer to chart above.
Telephone Programming Instructions
To enter data for Program 11-12 (Service Code Setup (for Service Access)):
1. Enter the programming mode.
2. Enter 11 12
3. Enter the number of the item you want to program.
4. Enter data for the item you selected + HOLD.
5. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB
11-12-56
-Not Used-
-
-
11-12-57
Tandem Trunking (Unsupervised Conference)
KTS,SLT
753
11-12-58
Transfer into Conference
KTS,SLT
No
Setting
Prog. No. Item Terminals Default
Related
Program
11-12-01
Bypass Call 807
11-12-xx
xxxxx