NEC Xen Topaz - Page 55

Xen Topaz Programming Manual 48
Program 10 to 11
PROGRAM 11: SYSTEM NUMBERING
11-15: S
ERVICE CODE SETUP (FOR SPECIAL ACCESS)
Description
Use Program 11-15 : Service Code Setup, Administrative (for Special Access) to customize the special
access Service Codes which are used by the administrator. You can customize additional Service Codes in
Programs 11-10 through 11-12 and 11-16.
The following chart shows:
• The number of each code (01-11)
• The function of the Service Code.
• What type of telephones can use the Service Code.
• The code’s default entry.
• Programs that may be affected with the changing the code.
Input Data
Conditions
None
Feature Cross Reference
Refer to chart above.
IN
SA
SB
Prog. No. Item Terminals Default
Related
Program
11-15-01
Remote Maintenance (PC Programming )
830
11-15-02
-Not Used-
-
-
11-15-03
Backup Data Save
KTS
6322
90-03
90-04
11-15-04
-Not Used-
-
-
11-15-05
System Programming Mode, Log-In
KTS
6321
11-15-06
-Not Used-
-
-
11-15-07
Recording Destination in Dial-In Conversion Table
No
Setting
11-15-08
Network Message Lamp Control
No
Setting
11-15-09
Transfer to Trunk Ring Group Code
Allows a call to be transferred to the Universal Night
Answer External Paging zones.
No
Setting
16-02
11-15-10
-Not Used-
-
-
11-15-11
Ethernet Port Reset
No
Setting