NEC Xen Topaz - Page 78

Program 12 to 15
Xen Topaz Programming Manual 71
PROGRAM 14: TRUNK BASIC SETUP
14-01: B
ASIC TRUNK DATA
Description
Use Program 14-01 : Basic Trunk Data Setup to set the basic options for each trunk port. Refer to the
chart below for a description of each option, its range and default setting.
Input Data
IN
SA
SB
Trunk Port Number 1-51
Prog. No. Item Input data Default Related Program
14-01-01
Trunk Name
Set the names for trunks. The
trunk name displays at display
keysets for incoming and outgo-
ing calls.
Up to 12 Characters Refer be-
low
14-01-02
Transmit CODEC Gain Type
Use this option to select the
CODEC gain for the trunk.
The option sets the amount of
gain (signal amplification) for
the trunk
you are programming.
1-63
(-15.5dB - +15.5dB in
0.5dB intervals)
COI = 32
(0Db)
ISDN =
28 (-2dB)
14-01-03
Receive CODEC Gain Type
Use this option to select the
CODEC gain for the trunk.
The option sets the amount of
gain (signal amplification) for
the trunk
you are programming.
1-63
(-15.5dB - +15.5dB in
0.5dB intervals)
32
(0 dB)
14-01-04
Transmit Gain Level for Con-
ference and Transfer Calls
Use this option to select the
CODEC gain type used by the
trunk when it is part of an
Unsupervised Conference.
1-63
(-15.5dB - +15.5dB in
0.5dB intervals)
22
(-5dB)
14-01-05
Receive Gain Level for Con-
ference and Transfer Calls
Use this option to select the
CODEC gain type used by the
trunk when it is part of an
Unsupervised Conference.
1-63
(-15.5dB - +15.5dB in
0.5dB intervals)
22
(-5dB)
14-01-06
SMDR Print Out
Use this option to have the sys-
tem
include/exclude the trunk you
are programming from the
SMDR printout. See Program
35-01 and 35-02 for SMDR
printout options.
0 : No Printout
1 : Printout
1
14-01-07
Outgoing Calls
Use this option to allow/prevent
outgoing calls on the trunk you
are programming.
0 : Prevented
1 : Allowed
1