NEC Xen Topaz - Page 79

Program 12 to 15
Xen Topaz Programming Manual 72
Input Data (cont)
Prog. No. Item Input data Default Related Program
14-01-08
Toll Restriction
Use this option to enable/
disabled Toll Restriction for the
trunk. If enabled, the trunk fol-
lows Toll Restriction program-
ming
(ex: Programs 21-05, 21-06). If
disabled, the trunk is a toll free
line.
0 : Restriction Disable
1 : Restriction Enable
1
21-04
21-05
21-06
14-01-09 -Not used-
-
-
14-01-10
DTMF tone for Outgoing Calls
Use this option to enable (1) or
disable (0) DTMF back tones
for outgoing trunk calls.
0 : Disable
1 : Enable
0
14-01-11
Account Code required
0 : Disable
1 : Enable
1
14-01-12 -Not Used-
-
-
14-01-13
Loop Disconnect Supervision
Use this option to enable (1) or
disable (0) loop supervision for
the trunk. This option is re-
quired for Call Forwarding Off-
Premise and Tandem Trunking
only.
0 : Disable
1 : Enable
0
14-01-14
Long Conversation Cutoff
Use this option to enable or
disable the Long Conversation
Cutoff feature for each trunk.
0 : Disable
1 : Enable
0
20-21-03
20-21-04
14-01-15
Long Conversation Alarm
before Cutoff
Use this option to enable or
disable the Long Conversation
Alarm for each trunk.
0 : Disable
1 : Enable
0
14-01-16
Forced Release of Held Call
Use this option to enable/
disable forced release for calls
on Hold. If enabled, the system
disconnects a call if it is on Hold
longer than a programmed in-
terval (Program
24-01-05). If disabled, forced
disconnection does not occur.
Program 24-01-01 also affects
this option.
0 : Disable
1 : Enable
0
14-01-17
Trunk to Trunk Warning Tone
for Long Conversation Alarm
Use this option to enable or
disable the Warning Tone for
Long Conversation feature for
DISA callers.
0 : Disable
1 : Enable
0