Program 12 to 15
Xen Topaz Programming Manual 73
Input Data (cont)
Default
14-01-01: Trunk Name
Conditions
None
Prog. No. Item Input data Default Related Program
14-01-18
Warning Beep Tone Signaling
0 : Disable
1 : Enable
0
14-01-19
Privacy Mode Toggle Option
Use this option to enable or
disable a trunk’s ability to be
switched from private to non-
private mode by pressing the
line key or Privacy Release
function key.
0 : Disable
1 : Enable
0
14-01-20
Block Outgoing Caller-ID
Allow (0) or Block (1) the sys-
tem from automatically sending
outgoing Caller ID information
when a user places a call. If
blocked, the system automati-
cally inserts the Caller ID block
code (defined in 14-01-21) be-
fore the user dialled digits.
0 : Allow
1 : Block
0
14-01-21
Caller-ID Block Code
Enter the code, up to 8 digits,
that should be used as the
Caller ID Block Code. This code
is automatically inserted before
dialled digits if Program 14-01-
20 is set to ‘1’.
0 : Dial (Up to 8 digits)
1 : Enable
No set-
ting
14-01-22
Not Used
-
-
14-01-23
Least Cost Routing
0 : LCR Off
1 : LCR On
2 : LCR On (Cost Cen-
ter Code only)
0 26-01-04
26-05 to 26-08
14-01-24
Trunk to trunk Outgoing
Caller ID Through Mode
When a call is transferred from
trunk-A to trunk-B (IP Trunks
only), the Caller ID data from
trunk-A can be sent to trunk-B.
0: Disabled
1: Enabled
0
Trunk Port Number Name
1 Line 01
2 Line02
: :
51 Line 51
To Next Page
Loading...
