NEC Xen Topaz - Page 92

Program 12 to 15
Xen Topaz Programming Manual 85
PROGRAM 14: TRUNK BASIC SETUP
14-09: C
ONVERSATION RECORDING DESTINATION FOR TRUNKS
Telephone Programming Instructions
To enter data for Program 14-09(Conversation Recording Destination for Trunks):
1. Enter the programming mode.
2. Enter 14 09
3. Enter the number of the item you want to program.
4. Select the Trunk port number to programmed by pressing the FLASH or the VOLUME▲ or VOLUME▼
keys.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press DC once to enter a new item number.
OR
Press DC until you’ve exited that series’ programming section.
IN
SA
SB COPY
14-09-01 Trunk1
Rec Dest Ext
14-09-xx Trunkxx
xxxxx