NSK Megatorque PS Series - Restoring Parameters

— 8-64 —
8.9.3.3. Restoring Parameters
 This section describes the way to send the captured text file to the Driver Unit.
1) Launch Hyper Terminal.
◊ [Start] → [Programs] → [Accessories] → [Communications] → [Hyper
Terminal].
There is the icon you have made in the menu
2) Send the file that stores the parameter settings to the Driver Unit.
◊ Send the file following the steps below.
[Transfer] → [Send Text File…].
3) Input the parameter AO and the parameter MM, whose settings are being captured.
(1) Input the parameter AO.
:
/
NSK ON
NSK ON
:AO123456
:_
O 1 A 3 4 2
6
ENT
5
N S /
SP
K
N
ENT
O
(2) Input the parameter MM.
:
/
NSK ON
NSK ON
:MM1
:_
M 1 M
ENT
N S /
SP
K
N
ENT
O