NSK Megatorque PS Series User Manual

— 3-8 —
3.3.4. Connector Wiring
！
Caution : Be sure to install a surge killer circuit when inductive switches such as
relays are used.
！
Caution : When inputting the inputs “Over travel limit, + direction” and “Over
travel limit, - direction,” connect the outputs of your sensors directly to
the inputs, not via the master controller. (Those connectors are shown
as
in Figure 3-8 below.)

NSK Megatorque PS Series Specifications

General

Brand	NSK
Model	Megatorque PS Series
Category	Engine
Language	English