NSK Megatorque PS Series User Manual

— 4-1 —
4. Handy Terminal Communication
 Function of Handy Terminal
 Monitoring the Motor conditions, internal channel programming and setting parameters with the
RS-232C communication interface can be done easily by connecting the FHT21 Handy Terminal
to connector CN1 of EDC Driver Unit. (No setting such as baud rate is required.)
！
Caution : When connecting or disconnecting the communication cable (CN1), be
sure that the power of the Driver Unit is turned off.
 Appearance and function of each part
Fig 4-1: Handy Terminal M-FHT21
86
HANDY TERMINAL
NSKNSK
Numeric keys
Code keys (superscript)
Connector
106
90
Alphabetic keys
Special code keys
3
<
2
$
1
#
-
+
5
%
4
>
8
(
7
‘
6
&
.
=
0
?
9
)
CB A FED
IH G LKJ
ON M RQP
UT S XWV
?Z Y
＊
/
,
CTRLESC SHIF
T
ENTSPBS
SHIFT : Shift key
N
o
t
e
1)
ESC : Escape key (Not used)
CTRL : Control key
Note 2)
BS : Back space key
Note 3)
SP : Space key
Note 4)
ENT : Enter key
Note 5)
Frame
LCD
195
27
Cable
(Cable length: 3000)
Note: 1) SHIFT: Press a numeric key while pressing the SHIFT key to enter a code key.
A superscript of the numeric keys will be entered.
2) CTRL: A specified alphabetic key becomes valid when pressing the CTRL key
together.
3) BS: Press the BS key when correcting logged in mistakes.
4) SP: Use this key to input a blank between letters.
5) ENT: Press the key at the end of a command or the parameter setting.

NSK Megatorque PS Series Specifications

General

Brand	NSK
Model	Megatorque PS Series
Category	Engine
Language	English