To Next Page

To Previous Page

— 9-3 —

9.1.5. Wildcard Search

 When a letter of alphabet is specified following the “?”, all corresponding commands and

parameters will be displayed.

◊ When only the “?” is inputted, all commands and parameters will be displayed.

The prompt “;” is on the end of each line when reading out multiple commands or

parameters. In such a case, press the SP key to scroll to the next menu or terminate the

readout by the BS key

PG0.12;

PGL0.05;

PC0.1

PS1;

PK0;

PWU0;

PWV0;

PWW0;

PF50.00

9.1.6. Repeating Readout

 When an option code “/RP” is added to a readout command such as the command TP, the

System repeats to display the readout.

◊ A press of the BS

key terminates repetitive readout.

?SG/RP

SG 6 _

 Adjust the parameter MR (Monitor refresh rate) when the settings of parameters are hard to read

because of their frequent changes. The readout stays on the display for a time set by the

parameter MR for easy confirmation of readout.

Questions and Answers:

Need help?

Do you have a question about the NSK Megatorque PS Series and is the answer not in the manual?

NSK Megatorque PS Series Specifications

General