NSK Megatorque PS Series - Page 299

— 9-75 —
Ì WD: Write Data
 This command backs up the current settings of the parameters, programs and control
inputs/outputs to the EEPROM.
◊ Refer to “8.9. RS-232C Communication” for details.
 If the parameter WM (Write mode to EEPROM) is set to WM1, execution of the WD command
will forcibly back up the settings to the EEPROM.
Category Command
Format WD
！
Caution : For backing up all data which are currently set, it requires
approximately 40 seconds. If the control power is turned off during
saving the data, the alarm E2 (ROM error) may occur when the power
is tuned on next time.
WHL (Application use only)
 This parameter is only used for the EDC MegaTerm. Do not change the setting. .
WHR: (Application use only)
 This parameter is only used for the EDC MegaTerm. Do not change the setting. .
WLA: (Application use only)
 This parameter is only used for the EDC MegaTerm. Do not change the setting. .
WLB: (Application use only)
 This parameter is only used for the EDC MegaTerm. Do not change the setting. .
WLC: (Application use only)
 This parameter is only used for the EDC MegaTerm. Do not change the setting. .
WLD: (Application use only)
 This parameter is only used for the EDC MegaTerm. Do not change the setting. .