5) Input the command SV (Servo on) to turn on
the servo of the Motor..
:
S
:_
VS
ENT
◊ When setting the input OTP to the normally closed contact, input the command PI2 and follow
the procedure above.
◊ When setting the input OTM to the normally closed contact, input the command PI3 and follow the
procedure above.
4. Others
Combination of the Motor and the Driver Unit shall conform to the specification.
Be sure to keep the record of parameter settings.
Do not modify the cable set.
Lock the connectors securely and check for loose fixing screw(s).
Please keep expendable parts and backup parts. (The Motor, the Driver Unit and the Cable set for replace)
Use alcohol for cleaning, and never apply thinner.
To Next Page
Loading...
Need help?
General
