Olympus EPOCH 1000 Series - Page 354

910-269-EN, Rev. B, June 2011
342 Index
analog out connector 20, 31, 32
pinout 317
analog outputs 128
angle beam modes 136
angle beam transducer
calibrating (PA) 290
calibrating (UT) 153
A-scan ruler 261
ASME III DAC setup example 199
ASME/ASME III DAC/TVG 199
ASTM E164 IIW Type calibration block 168
audible alarm 120
audience 15
Australia. EMC compliance 2
auto measurement reading, tip 135
auto-calibration
scope, note 133
single thickness test block, note 145
single thickness test block, tip 140
automatic probe ID (PA) 239
AUTO-XX% 90
feature using 90
usage, note 90
AWS
calculating A and C values 233
D1.1 description 229
D1.1 option activation 230
D1.1 software option 229
scanning gain 232
software feature, activating 230
B
back stand 20
back-wall echo capture, note 151
battery
charge status 40
charging internally 44
CompactFlash in compartment 33
compartment cover 20, 33
compartment thumb screws 33
compartment vent 20
complete charge/discharge cycles 43
connections in compartment 32
life, note 249
location in compartment 33
maximizing life, note 93
operating time 43
replacing 46
usage instructions 45
USB host port in compartment 33
using 42
beam
menu 240
parameter calculation, note 244
spreading echo disregarding, note 159
beam index point (BIP)
locating 154
peak memory, tip 155
beep, gate alarm 120
best fit feature
important note 260
note 260
best fit mode 258
BNC connector 4, 20, 28
building a TVG setup with TVG table 217
C
calibrating
depth distance 163
getting started in PA mode 275
in echo-to-echo mode using a delay line
transducer 150
PA mode 275
sensitivity 160
sensitivity with a zero degree transducer 286
sensitivity with an angle beam transducer
299
sound path distance 157
using a delay line transducer 140
using a dual element transducer 146
using a straight-beam transducer 137
using a zero degree transducer 278
using an angle beam transducer (PA) 290
using an angle beam transducer (UT) 153
velocity with a zero degree transducer 279
velocity with an angle beam transducer 290
wedge delay with a zero degree transducer
282
wedge delay with an angle beam transducer
294
zero degree transducer 278
calibration
Downloaded from ManualsNet.com search engine