Tungsten™ E2 Handheld 88
CHAPTER 5 Moving Info Between Your Handheld and Your Computer
Cont’d.
HotSync Enabled/Disabled Sets your computer to respond to synchronization
requests from your handheld.
Enable HotSync software at system startup Sets your computer to
automatically respond to synchronization requests each time you start your
computer. If this option is not selected, you must open HotSync Manager and
select the Enabled option before you can synchronize.
Show more detail in H
otSync Log Includes more troubleshooting information
in the log that is generated when you synchronize.
3 Close the HotSync Software Setup window.
Done
To Next Page
Loading...
