palmOne Tungsten E2 - Adding or Updating a Contact Directly from a Message

Tungsten™ E2 Handheld 353
CHAPTER 15 Sending and Receiving Email Messages
Adding or updating a contact directly from a message
You can add an email address in Contacts directly from the body of a received email message.
0
1 Open the Add Contact dialog box:
a. Open the message you want.
b. On the message screen, open the menus
.
c. Select Options, and then select Add to Contacts.
2 [ & ] OPTIONAL If a Display Name exists for this Contacts record, the dialog
box displays the name in the Last name and First name fields.
If the Last name and First name fields are blank, enter the first and last name
associated with the “From” email address.
3 Select OK to add the email address to Contacts, and then select OK in the
confirmation dialog box.
Done
Tip
You can also update an
existing Contacts record
with a new email address,
or create a second
Contacts record for a
name that has an existing
record. The procedure is
the same as for adding a
new Contacts record. If
you select Add to
Contacts from the body of
an email message and a
record already exists for
the recipient name, you
are prompted to either
update the email address
for the recipient or create
a new record for the
recipient.