Tungsten™ E2 Handheld 589
CHAPTER 28 Common Questions
3. Select Delete Password to remove the password and delete all private records.
4. Synchronize your handheld with your computer again.
I forgot the password, and my handheld is locked.
First, use the password hint to try to remember the password. If this doesn’t help or if you do not
have a password hint, you must perform a hard reset
to continue using your handheld. Performing
a hard reset deletes all of the information on your handheld. To protect your info and create a
backup of your info, synchronize the information in your handheld’s program memory with your
computer.
Sharing
I can’t beam information to another handheld or other device.
Depending on the receiving handheld model, not all information may be sent correctly.
• If you are beaming to another Palm Powered device, confirm that your handheld and the other
handheld are 4 to 39 inches (approximately ten centimeters to one meter) apart and that the path
between the two handhelds is clear of obstacles. Beaming distances to other devices with an IR
port may be different.
• Move your handheld closer to the receiving device.
• Make sure the receiving device has beam receive enabled
.
• Perform a soft reset
on both your handheld and the receiving device.
• Avoid beaming in bright sunlight or fluorescent light. These produce infrared noise that can
make beaming go slower or, in some cases, prevent it from working at all.
NOTE
To Next Page
Loading...
