Philips Expression MR400 - Page 105

ExpressionMR400InstructionsforUseGettingStarted3‐19
– OnturnsontheECGparameter.(Default)
• NIBPallowsnon‐invasivebloodpressuremonitoring(doesnothaveanassociated
waveform):
– OffturnsofftheNIBPparameter.
– OnturnsontheNIBPparameter.(Default)
• P1allowsinvasivebloodpressuremonitoring:
– Off
turnsofftheP1parameter.(Default)
– OnturnsontheP1parameter.
• P2allowsinvasivebloodpressuremonitoring:
– OffturnsofftheP2parameter.(Default)
– OnturnsontheP2parameter.
• SPO2allowsoxygensaturationofarterialbloodmonitoring:
– OffturnsofftheSPO2

parameter.
– OnturnsontheSPO2

parameter.(Default)
• CO2allowsCO2andCO2‐derivedrespirationratemonitoring:
– OffturnsofftheCO2

parameter.(Default)
– OnturnsontheCO2

parameter.
NOTE
If CO2 is turned Off, AGENT and GAS will also be deactivated.
• RESPallowsresp irationratemonitoringusingthebellows(doesnothaveanassociated
waveform):
– Offturnsoffthebellows‐derivedrespirationparameter.(Default)
– Onturnsonthebellows‐derivedrespirationparameter.
NOTE
If CO2-derived respiration is on, then RESP will not be selectable. To use bellows respiration,
select BEL in the RESP menu; see page 10-5.
• TEMPallowstemperaturemonitoring(doesnothaveanassociatedwaveform):
– Offturnsoffthetemperatureparameter.(Default)
– Onturnsonthetemperatureparameter.