Philips Expression MR400 - Alarm Volume; Alarm Reset

ExpressionMR400InstructionsforUseAlarms4‐7
Alarm Volume
Theloudnessofthealarmsoundscanbeadjusted(45–86dB,typical).
WARNING
Always ensure that the alarm sound setting is appropriate for each patient. The alarm sound
volume is adjustable for suitability to various clinical environments. When you use the
MR400, always ensure that the alarm sound can be heard above the ambient noise level.
Failure to do so may cause a lapse in patient monitoring.
Tocontrolthealarmvolume
Alarm Reset
Resettingthealarmresultsinthefollowingalarmsystembehaviors:
•Theauditoryalarmsignalsofphysiologicalalarmconditionscease,enablingthealarm
systemtorespondtoasubsequentalarmcond ition.
•Alarmlightindicationscease.
•Alarmflagsforanyexistingalarmscontinueaslongasthosealarmconditionsexist.
•Thealarmsystem
isenabledimmediatelysothatitcanrespondtoasubsequentalarm
condition.
•ThevisualalarmsignalsofINOPconditionsdonotceaseaslongastheINOPalarm
conditionexists.
ThealarmcanberesetbypressingtheAudioPausekeyonetime.
Step Action
1PresstheSetupkeyandthenthe
Monitorkey.
TheMonitorSetupmenuappears.Currentsettingsaredisplayed.
2OntheMonitorSetupmenu,selectSoundAdjust.
TheSoundAdjustmenuappears.Currentsettingsaredisplayed.
3 SelectAlarmVolume.
1–10
Themenuitemappears.Thecurrentsettingishighlighted.
4 Selectthedesiredsettingfromthemenuoptions.
Thesettingis
enteredandamomentarysoundatthe
correspondinglevelisproduced