Philips Expression MR400 - Patient Preparation for CO2 Monitoring; Selecting the CO2 Accessory; Connecting the Sampling Line

7‐4MonitoringCO2(LoFloOption) ExpressionMR400In structions forUse
Patient Preparation for CO2 Monitoring
Whenpreparingapatient,theaccessorypositiononthepatientwillimpacttheperformanceand
operationoftheCO2parameter.
Selecting the CO2 Accessory
Inpatientsonabreathingcircuit,asampleoftherespiratorygasisdrawnfromthepatient’s
breathingcircuitthroughanairwayadapterandagassamplingline.Inpatientswhoarenotona
breathingcircuit,thegassampleisdrawnthroughanasalcannula.Thesespeciallydesigned
cannulasand
on‐airwayadaptersincorporateafi lterandsamplecelltoprovidemaximum
filtrationoffluidsandcontaminantstoprotectagainstsystemintake.WhenselectingCO2

accessories(seepage1‐34foralisting),considerthefollowing:
•Thetypeofpatient(adult,pediatric,orneonatal)
•Whetherthepatientisreceivingsupplementaloxygen
•Theconditionofthepatient
•Allaccessoriesaresingleuse.
Connecting the Sampling Line
Toconnectthesamplingline
Step Action
1InsertthesamplinglineconnectorintotheCO2portonthepatient
connectionpanelandthenpushtheconnectorforwarduntilyou
feelorhearitclickintoplace.
Sampling line connector
CO2 port