Philips Expression MR400 - System Components; Use Model

2‐2SystemOverviewExpressionMR400InstructionsforUse
•Non‐invasivebloodpressure(NIBP)
• Respirationrate(CO2orbellows)
Note
Depending upon the equipped options, your MR400 may not have all indicated parameters.
System Components
Beforeuse,familiarizeyourselfwiththeMR400anditscomponents.AcompleteMR400system
consistsofthefollowingcomponents:
• MR400cart
•wECGmodule
•wSpO2module
•Modulebatterycharger
• Batteriesandotheraccessoriesasneeded
•Optional:IP5withorwithoutaprinter
Use Model
TheMR400isintendedtobeusedtomonitorthevitalsignsofapatientinanMRmagnetroom,
asillustratedbelow.ThewECGandwSpO2modulescommunicateviawirelesslinkstosupplythe
patient’smeasuredECG,SPO2,andbellows‐derivedrespirationsignalstotheMR400.Thegating
cableis
onlyrequiredforMRItriggeringandsynchronizationbasedonthepatient’sECGorSPO2
signals.WhenpairedwithanoptionalIP5,monitoringcapabilitycanbeextendedviawirelesslink
toanMRcontrolroom,inductionroom,orrecoveryroomenvironment.Datatransmittedfrom
theMR400toanIP5canbe
outputtoanoptionalstripchartprinterortothehospitalinformation
system(HIS).