Philips Expression MR400 - Technical (INOP) Alarms and Other Status Flags; ECG

ExpressionMR400InstructionsforUseAlarms4‐31
Technical (INOP) Alarms and Other Status Flags
ThefollowingtablecontainsalistingoftheINOPandotherstatusalarmflagmessages,locations,
toneindications,andwhereapplicablepossiblesolutions.
ECG
Violated non-invasive
blood pressure mean
value
NIBP The non-invasive blood pressure
mean measurement has violated an
alarm limit setting.
Flashing yellow mean numeric in the NIBP VS
box, yellow alarm light, medium priority alarm
tone, where OVR displayed if the value is
greater than the highest specified or UND if
the value is less than the lowest specified
Violated non-invasive
blood pressure diastolic
value
NIBP The non-invasive blood pressure
diastolic measurement has violated
an alarm limit setting.
Flashing yellow diastolic numeric in the NIBP
VS box, yellow alarm light, medium priority
alarm tone, where OVR displayed if the value
is greater than the highest specified or UND if
the value is less than the lowest specified
Missing non-invasive
blood pressure data
NIBP The non-invasive blood pressure
data, once present, can no longer
be produced.
Flashing yellow dashes (- - -) in the systolic,
diastolic and mean numerics in the NIBP VS
box, yellow alarm light, medium priority alarm
tone
Patient Alarm From Condition Indication
Message, Location,
Indication
What to Do
Lead Fail
ECG alarm flag area, blue
alarm light, INOP alarm
tone
An ECG lead (or electrode) required to measure the lead view is faulty or disconnected:
• Ensure that the ECG lead cable is connected to the wECG module, and that the wECG module
has sufficient battery power.
• Ensure that each ECG lead cable clip is connected to the Quadtrode electrode contact.
(Examine the ECG VS box for indications of a contact problem, where LL = left leg, LA = left
arm, and RA = right arm, and LL, LA, RA, = RL [right leg] or all leads.)
• Replace the ECG lead cable.
• Replace the Quadtrode electrode.
Notes
• The error message can be displayed for trace A and/or for trace B.
• May also be displayed when high DC offsets are present on an input lead.