Philips Expression MR400 - Trace 1

ExpressionMR400InstructionsforUse TrendDataandPrinting13‐13
Trace 1
Printsaselectedparameter’swaveformintheTrace1waveformlocationonastripchart,as
shownintheillustrationbelow.(Astripcancontaintwowaveforms.)
Note
If Trace 2 is off, then Trace 1 is printed using the full 40 mm width of the strip.
Thefollowingoptionsareavailable:
•ECG1outputstheTraceAwaveform(Default)
4 Selectthedesiredsettingfromthemenuoptions.
Thesettingisentered.
5Tochangeothersettings,repeatsteps2,3and4.
1 Trace 1 setting
2 Date and time (formatted as MM/DD/YY-HH:MM:SS)
3 Patient type
4 Trace delay
5 Trace speed
6 Parameter setting information
7 Values of active parameters at time of printing
8 Trace 2 parameter information
9 Trace 2 setting
10 Trace 2 waveform
11 Trace 1 waveform
Step Action
1
2
3
4
5
6
7
8
9
11
10