Philips Expression MR400 - Sweep Speed; Resp Speed

ExpressionMR400InstructionsforUseGettingStarted3‐25
Sweep Speed
Setsthesweeprateforallwaveforms(displayedandprinted),exceptCO2.
ToopentheSweepSpeedmenu
PresstheSetupkeyandthentheMonitor
key.OntheMonitorSetupmenu,select
SweepSpeed.
Thefollowingspeeds(inmillimetersper
second)areavailable:
•50mm/s
•25mm/s(Default)
Toadjustthe
sweeprateforallwaveforms(exceptCO2)
Resp Speed
SetsthesweepratefortheCO2waveform.
ToopentheRespSpeedmenu
1 50 mm/s
2 25 mm/s
Step Action
1PresstheSetupkeyandthentheMonitorkey.
TheMonitorSetupmenuappears.Currentsettingsaredisplayed.
2OntheMonitorSetupmenu,selectSweepSpeed.
TheSweepSpeedmenuappears.The currentsettingishighlighted.
3 Selectthedesiredsettingfromthemenuoptions:
50mm/s
25mm/s
Thesettingisentered.
1
2