Philips Expression MR400 - Printing Functions; Printing Parameter-Specific Trends; Controlling Printer Outputs

13‐10TrendDataandPrinting ExpressionMR400InstructionsforUse
Printing Functions
WhenequippedwithanIP5andprinter,theMR400can producehardcopiesofuptotwo
waveforms,trendinformationandpatientda tareports.
Notes
• If a printer-equipped IP5 is not installed or connected, an indication is displayed on the
Print key; see page 13-11.
• Any print command from the MR400 automatically initiates a 30-second print cycle at the
IP5.
• Any print command initiated from the MR400 takes precedence over the IP5 print functions.
Printing Parameter-Specific Trends
Trendedinformationcanbeprintedseparatelyforeveryparameter(exceptbellows‐derived
respiration).
Toprintindividualtrenddata
Controlling Printer Outputs
Tostartandstopthe printingofastripchart,pressthePrintkey.
Iftheprinterisallowedtorunafterprinting,paperwillcontinuetobeoutputforabout30
secondsbeforeautomatically stopping.
Step Action
1PresstheTrendskey.
TheTabularTrendsmenuappears.Allowthetrendsdatato
refresh.

2 Selectthetrendbuttonoftheparameterthatyouwanttoprint.
Thecorrespondingvitalsigndataappears.Thecurrentpageis
displayed.
3 SelectPrintAlltoprintallthedatafortheparameter,orselect
PrintPagetoprintthecurrentlydisplayeddata.
ThedataisprintedattheIP5.