Philips Expression MR400 - Trace 2

13‐14TrendDataandPrinting ExpressionMR400InstructionsforUse
•ECG2outputstheTraceBwaveform
•SPO2outputstheTraceCwaveform
•RESP(CO2)outputstheTraceDwaveform
•P1outputstheTraceEwaveform
•P2outputstheTraceFwaveform
ToprintawaveformintheTrace1location
Trace 2
PrintsawaveformintheTrace2locationonastripchart(seeexample,onpage13‐13).
Note
When printing two traces, the waveform to grid ratio will not correspond to the displayed
waveform/scale indicator size.
Thefollowingoptionsareavailable:
•Off(Default)
•ECG1outputstheTraceAwaveform.
•ECG2outputstheTraceBwaveform.
•SPO2outputstheTraceCwaveform.
• P1outputstheTraceEwaveform.
Step Action
1PresstheSetupkeyandthenthePrinterkey.
ThePrintermenuappears.Currentsettingsaredisplayed.
2 SelectTrace
1.
TheTrace1menuappears.Thecurrentsettingisdisplayed.
3 Selectthedesiredsettingfromthemenuoptions:
ECG1
ECG2
SPO2
RESP(CO2)
P1
P2
Thesettingisentered.