Philips Expression MR400 - Attaching the SpO2 Probe to the wSpO2 Module

1‐18ImportantInformationExpressionMR400InstructionsforUse
Attaching the SpO2 Probe to the wSpO2 Module
TheSpO2probe,necessaryfortakingSpO2‐relatedmeasurementsusingthewSpO2module,
mustbeconnectedprioruse.
WARNINGS
• Only perform this attachment at a location outside of the MR magnet room. Failure to
observe this warning may result in serious injury.
• Connecting an other than specified SPO2 probe to the wSpO2 module can cause
inaccurate SPO2 readings and damage the module.
ToattachtheSPO2probe
InserttheSPO2probeconnectorintotheDB‐9connectoronthewSpO2
modulethensecurelytightenbothscrews.
5LocatethebatteryswitchandtoggleitintotheOn(I)position.
6 Reinstalltheservicepanelcover,andsecureittotheWPUusing
thetwoscrews.
7Replacetheshieldcap.
Thiscompletestheinstallati on andconnectionofthemainand
reservebatteries.ConnectACmainspowerthenallowthese
batteriestochargeforatleast12hoursbeforeinitialuse;seepage
1‐21.
Step Action
Battery switch
1 wSpO2 module
2 DB-9 connector
3 SPO2 probe connector
4 Screws
3
4
2
1