Philips Expression MR400 - Cart Power-down; Wireless Module Power-down; Monitor Initialization

3‐6 GettingStartedExpressionMR400InstructionsforUse
CAUTION
If power to the wireless device with established communications is lost or removed, its network
connection will be dropped.
Cart Power-down
ToturnpowerofftotheMR400,pressthenholdthepowerswitchforapproximately2seconds.
NOTE
For instructions on the complete removal of power to the MR400, see page 14-2.
Wireless Module Power-down
Toturnpowerofftoawirelessmodule,remove thebattery(wSpO2module)orbatteries(wECG
module).
Monitor Initialization
Afterpower‐upanduntiltheinitializationprocesscompletes,thetouchscreenmayremain
blank.Afterinitializationcompletes,theMR400canbeginmonitoringfunctionsfromanin itial
factorydefaultstateorfromapre‐configuredstate,dependinguponthewaythestored
configurationsandpatientdataareprogrammedforstartup.
Visually
checkingthepatientandconfirmingchangingmeasurementsagainstothervitalsigns
shouldbestandardroutinesduringuse.
14 (Optional)IfequippedwithanIP5,ensuregoodcommunication
betweentheMR400andtheIP5bycheckingthestatusinformation
pane(seepage2‐16).
15 Ensureproperoperationofeachpatientparameterandalarms.
Refertoappropriatechaptersinthismanual.
Step Action